![]() ![]() Attach required files including configuration files to reproduce the error.If you use an older version, update your software and check if the error has been corrected.) Which software version are you using? (We support only the latest version.4 flashes: loader.bin/start.elf cannot launch. 3 flashes: loader.bin/start.elf not found. With which Repetier product you have a problem? Besides, if Raspberry Pi won’t turn on, the ACT LED flashing in a specific pattern could also tell you something about the boot problem: 1 flash: incompatible SD card.But if questions are already answered on our site, we will not answer them again personally. We are of course happy about bug reports. If fins are not aligned vertically, or if fins are too close together to allow sufficient air flow between them, the efficiency of the heat sink will decline. Natural convection requires free flow of air over the heat sink. If in doubt set to Autodetect Best which uses the detected version to select best option. A heat sink is not a device with the 'magical ability to absorb heat like a sponge and send it off to a parallel universe'. Last thing is check if in Config Preferences 3D Visualization General Draw Method was set according to your drivers capabilities. Next Domain redirection using apache not working properly. Please note that we offer very limited personal support for our free software. Right mouse on the desktop, open switchable graphics, search repetier.exe and change it to maximum performance. Reading printer config /var/lib/Repetier-Server/configs/OLP.xml error: No element found in. If you can’t find any help on these pages, you can open a new thread or contact our support. We have troubleshooting pages for our Repetier-Host and for our Repetier-Firmware. And when the bed is heating u get the radiator icon. So when the bed is not heating then u get the lets say radiator-disabled icon. If you have any problems with Repetier software, you should first visit our forum or the reprap forum for general questions or operating and installation problems. I also have the repetier-server on my home assistant (see screenshot) But now i want to change the icons for bed heating and nozzle heating. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |